Hi there,
I've been with a new company using Creo 2.0 for the last three months and we would really benefit from being able to create parts with what I know as "configurations": I'm not sure what the equivalent term in Creo would be, I'm afraid.
The first parts I am trying to create are bent plates. There are 8 different versions, each sharing all bar two dimensions: an angle and the overall length which is driven by the angle. I've attached a 2d draft to demonstrate.
My target is a single part with 8 "configurations", with one drawing displaying this part in a default "configuration" and a table that will define parameters 'A' and 'L'.
I hope that this is feasible in Creo as it would save a lot of work!
Many thanks in advance.